My composite bow

139cm outter curve
Sal 26cm (bending part)
Kassan 10cm with horn and 15 without horn (non bending part)
Horn 6mm thick (overly thick, I know) from end of V-splice to quite near end of sal.
V-splice only 9cm long (should be longer....)

Limb width 32mm for most of sal, tapering some millimeter from mid limb

Handle namaskar wood. Limb white ash. 3 Piece construction.

I am aiming 55# @29", what thickness should I use for sal?

I was thinking of 15mm at end of V-splice,10mm in 4cm of sal and 9mm in sal-kassan transition point. Do you think this is reasonable ?

(NO need to answer anymore, It is allready done.)

I am thinking of putting perhaps 3mm sinew and wrapping the V-splice and 5-10cm at the start of kassan with under 1mm thick rawhide(best friend) on top of sinew.

All comments, specially constructively critical ones, welcome.